 |
| 3.5cm by 10cm |
 |
| 11cm, 7cm, 5cm and 4.5cm |
Sunday, 4 August 2013
Dimensions
Our new design!
 |
| This is the how our new design looks like |
 |
| The process of making our new product design |
Friday, 2 August 2013
New Design
My group mates and I decided to change our product even after troubleshooting which is mainly caused by the length problem which is too high. However, my group mates and I decided to change our design and we went to the fabrication shop on Friday to work on our new designs.
After much discussions and waiting time for the fabrication shop to open. In the end, we used Design 2 to restart on doing our CAN CAN CHALLENGE product. Designs are come up from Jiayi and some are changed as the whole group are discussing about using two motor or just one. In the end, we came up with using one motor with the help of Mechanism which we had learned in our Introduction to Engineering (MM).
Below are some brief details about our designs and other designs that we had designed.
After much discussions and waiting time for the fabrication shop to open. In the end, we used Design 2 to restart on doing our CAN CAN CHALLENGE product. Designs are come up from Jiayi and some are changed as the whole group are discussing about using two motor or just one. In the end, we came up with using one motor with the help of Mechanism which we had learned in our Introduction to Engineering (MM).
Below are some brief details about our designs and other designs that we had designed.
Sunday, 21 July 2013
Our Progress Week 14-16
Hello! This is Jiayi reporting.
Last week our project mates had come together and make our fabrication done at the lab. Its a wonderful, enjoying and fruitful progress and we had learnt lots of stuffs from the lectures.
However, when we are done with the fabrication of product, we encounter a problem. Our product was too high and it can only touched the tip of the can. Hence, my group mates and I decided to find out a problem and get some advice from our lectures and do our troubleshooting.
We hope that this product will be a success!
However, we are a bit out of time. So we decided to split work load.
(Below are pictures of some of the group mates doing the fabrication.)
[Although most of the picture are seen one of the group mate doing the fabrication, but all of us get to learnt from him as we did not take any subjects relating to the fabrication of a product.]
drilling of parts
smoothening of fabricated part
drilling of parts
Last week our project mates had come together and make our fabrication done at the lab. Its a wonderful, enjoying and fruitful progress and we had learnt lots of stuffs from the lectures.
However, when we are done with the fabrication of product, we encounter a problem. Our product was too high and it can only touched the tip of the can. Hence, my group mates and I decided to find out a problem and get some advice from our lectures and do our troubleshooting.
We hope that this product will be a success!
However, we are a bit out of time. So we decided to split work load.
(Below are pictures of some of the group mates doing the fabrication.)
[Although most of the picture are seen one of the group mate doing the fabrication, but all of us get to learnt from him as we did not take any subjects relating to the fabrication of a product.]
Things to do during week 14-16:
1. Workshop fabrication
2. Detail design
3. Fabrication of mechanism
4. Programming
5. Assembly of Mechanism
DONE / UNDONE
Sunday, 19 May 2013
Subscribe to:
Posts (Atom)