Last week our project mates had come together and make our fabrication done at the lab. Its a wonderful, enjoying and fruitful progress and we had learnt lots of stuffs from the lectures.
However, when we are done with the fabrication of product, we encounter a problem. Our product was too high and it can only touched the tip of the can. Hence, my group mates and I decided to find out a problem and get some advice from our lectures and do our troubleshooting.
We hope that this product will be a success!
However, we are a bit out of time. So we decided to split work load.
(Below are pictures of some of the group mates doing the fabrication.)
[Although most of the picture are seen one of the group mate doing the fabrication, but all of us get to learnt from him as we did not take any subjects relating to the fabrication of a product.]
Things to do during week 14-16:
1. Workshop fabrication
2. Detail design
3. Fabrication of mechanism
4. Programming
5. Assembly of Mechanism
DONE / UNDONE
No comments:
Post a Comment